Att CL81211 Manuel d'utilisateur télécharger pdf (Page 13)

Getting started

Installation options

Your telephone base is ready for tabletop use. If you want to mount your

telephone on a wall, use the provided wall mount bracket to connect with

a standard dual-stud telephone wall mounting plate. If you do not have this

mounting plate, you can purchase one from many hardware or consumer electronic

retailers. You might need a professional to install the mounting plate.

Tabletop to wall mount installation

1. Plug the power cord and telephone line into the telephone base. If you

are using a DSL filter, plug the other end of the telephone line into the

filter. Route the telephone line cord (or DSL filter) through the wall mount

bracket hole.

2. Position the telephone base as shown below. Insert the extended tabs (see

below figure 2) of the wall mount bracket into the slots on the back of

the telephone base (marked B). Push the telephone base down until it is

securely in place.

3. Plug the telephone line cord (or DSL filter) into the wall jack. Plug the power

adapter into a power outlet not controlled by a wall switch.

4. Align the holes on the wall mount bracket with the standard wall plate

and slide the wall mount bracket down until it locks securely. Bundle the

telephone line cord and power adapter cord neatly with twist ties.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Pas de commentaire

Att CL81211 Manuel d'utilisateur Page 13