Att DECT TL91178 Manuel d'utilisateur télécharger pdf (Page 9)

Bluetooth setup

To resume the auto connection

To resume the auto connection between the

paired device and the telephone base, you will

need to connect the device manually. Make sure

the Bluetooth feature is turned on in your cellular

phone. Select AT&T DECT 6.0 from the paired

device list in your cellular phone to reconnect.

If the connection is successfully resumed, the

status icon will display on the cordless handset

screen, and the light of the Bluetooth button on

the telephone base will be on steadily.

Replace a paired device

If you want to pair and connect a new device when

there is already a device paired with the telephone

base, press and hold the Bluetooth button on the

telephone base until it is flashing, then start with

step two of Pairing a device on page 6. If you

do not pair a new device within two minutes, the

Bluetooth light on the telephone base will turn off

and the system will return to idle mode.

NOTE: If the connection

between the paired

device and the telephone

base does not resume by

manually connecting the

device on the paired

device list, you will need

to unpair or deregister

the device from the

cellular phone. Make

sure the device is no

longer on the paired list

after deregistration; then

follow the steps in

Pairing a device on

page 6 to start the

pairing procedures again.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Att DECT TL91178 Manuel d'utilisateur Page 9